Error message during start-up

When I execute Dreamweaver MX on my computer I get this message in a white box:
"accessibility error: could not load enable2.vxd module" If I click on the
box it goes away and the program loads normally. However, that error is bound
to be bad news somewhere down the line.

Also, I can neither unistall the program nor can I install it again. The
problem is not my disk; I have installed Dreamweaver on my other computer and
it works just as it should. No error messages. So wassupp with that?

Is this DMX6.0 or DMX6.1?

--
Murray --- ICQ 71997575
Team Macromedia Volunteer for Dreamweaver
(If you *MUST* email me, don't LAUGH when you do so!)
==================
http://www.dreamweavermx-templates.com - Template Triage!
http://www.projectseven.com/go - DW FAQs, Tutorials & Resources
http://www.dwfaq.com - DW FAQs, Tutorials & Resources
http://www.macromedia.com/support/search/ - Macromedia (MM) Technotes
==================


"Stratomaster" <webforumsuser (AT) macromedia (DOT) com> wrote

When I execute Dreamweaver MX on my computer I get this message in a white
box:
"accessibility error: could not load enable2.vxd module" If I click on
the
box it goes away and the program loads normally. However, that error is
bound
to be bad news somewhere down the line.

Also, I can neither unistall the program nor can I install it again. The
problem is not my disk; I have installed Dreamweaver on my other computer
and
it works just as it should. No error messages. So wassupp with that?

Hi,

Can't u even uninstall it from the Add/Remove programs? If you do, don't
forget to remove your user settings as well manually from the folder
<drive>:\Documents and Settings\<username>\Application
Data\Macromedia\Dreamweaver

That might solve your problem..

Good luck