Cut and Paste ruins code.

#1

I have spent ages tabbing my code so it reads lovely.
If I then cut and paste in design view the tabbing get thrown out, but if I cut the code from code view and paste in code view it stays ok.
Is there any way around this?

Thanks for your time.

Regards

The Deak

#2

commands > apply source formatting?

joe

"the Deak" <webforumsuser (AT) macromedia (DOT) com> wrote

Quote:

I have spent ages tabbing my code so it reads lovely.
If I then cut and paste in design view the tabbing get thrown out, but if
I cut the code from code view and paste in code view it stays ok.
Is there any way around this?

Thanks for your time.

Regards

The Deak

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Cut and Paste ruins code.

Macromedia Dreamweaver Macromedia Dreamweaver Discussions (macromedia.dreamweaver)

Cut and Paste ruins code. - 09-01-2003 , 10:53 AM

Re: Cut and Paste ruins code. - 09-01-2003 , 11:59 AM